Repeat - Enterasys Matrix E1 1G694-13 Configuration Manual

Network Management
Monitoring Network Events and Status
9.2.2.4

repeat

Use this command to repeat a command shown in the command history buffer.
repeat [cmd_num] [iterations]
Syntax Description
cmd_num
iterations
Command Defaults
If no parameters are specified, the last command will be repeated.
Command Mode
Read-Write.
Example
This example shows how to use the repeat command to repeat cmd_num 1 (show arp in the
history buffer display). It is repeated once
Matrix>history
1 show arp
2 history
3 show ip
4 show cdp ge.0.1
5 history
Matrix>repeat 1 1
Matrix>show arp
LINK LEVEL ARP TABLE
destination
--------------------------------------------------------------------------
10.1.0.1
10.1.10.10
--------------------------------------------------------------------------
9-12 Matrix E1 Series (1G694-13) Configuration Guide
(Optional) Specifies the number of the command from
the history display.
(Optional) Specifies the number of times to re-execute
the command. Valid values are 0 to 2147483647.
Entering 0 causes the specified cmd_num to be repeated
endlessly until the user enters Ctrl+C.
gateway
00:00:1d:bc:df:bf
00:00:1d:1f:27:26
.
flags Refcnt
405 1
405 0
Use Interface
0
11338
host0
host0