Enterasys Matrix E1 1G694-13 Configuration Manual page 228

Matrix E1 CLI Quick Reference Guide
CLI Tasks, Commands and Syntax
CLI Task
CDP interval (set)
community (clear)
community (set)
community (show)
config (clear)
counters (show port)
disable (set port)
disconnect
download
enable (set port)
A-2 Matrix E1 Series (1G694-13) Configuration Guide
Command Function and Syntax
Sets the message interval frequency of the CDP discovery protocol.
For details, refer to
set cdp interval frequency port_string
Deletes SNMP community names. For details, refer to
Section 3.2.4.3.
clear community community_name
Sets SNMP community names and access policies. For details, refer
to Section 3.2.4.2.
set community community_ name access_ policy
Displays SNMP community names and access policies. For details,
refer to Section 3.2.4.1.
show community
Clears the user-defined configuration parameters stored in NVRAM.
For details, refer to
clear config
Displays counter statistics detailing traffic through the switch device
and through all MIB2 network devices. For details, refer to
Section 4.2.1.2.
show port counters [port_string] [mib2 | switch]
Does not apply to MATRIX
Disables one or more ports. For details, refer to
set port disable port_string
Closes an active console port or Telnet session. For details, refer to
Section 9.2.2.11.
disconnect [A.B.C.D | console]
Downloads a new firmware image to the device from a TFTP server.
For details refer to
dload ip_address filename [noreboot]
Enables one or more ports. For details, refer to
set port enable port_string
Section 9.2.1.5.
Section 9.2.1.1.
Section 3.2.3.2.
Section 4.2.2.1.
Section 4.2.2.2.