Show Netstat - Enterasys Matrix E1 1G694-13 Configuration Manual

9.2.2.7

show netstat

Use this command to display statistics for the device's active network connections.
show netstat [icmp | interface | ip | routes | stats | tcp | udp]
Syntax Description
tcp
udp
ip
icmp
routes
stats
interface
Command Defaults
If no parameters are specified, show netstat will be executed as shown in the
example below.
Command Mode
Read-Only.
Example
This example shows how to display statistics for all the current active network connections:
Matrix>show netstat
Active Internet connections (including servers)
PCB Proto Recv-Q Send-Q
-------- ----- ------ ------
1cc6314 TCP
1cc6104 TCP
1cc6290 UDP
1cc620c UDP
Table 9-2
(Optional) Shows Transmission Control Protocol (TCP)
statistics.
(Optional) Shows User Datagram Protocol (UDP)
statistics.
(Optional) Shows Internet Protocol (IP) statistics.
(Optional) Shows Internet Control Message Protocol
(ICMP) statistics.
(Optional) Shows the IP routing table.
(Optional) Shows all statistics for TCP, UDP, IP, and
ICMP.
(Optional) Shows interface statistics.
Local Address
------------------ ------------------ -------
0 0 0.0.0.0.80
0 0 0.0.0.0.23
0 0 0.0.0.0.162
0 0 0.0.0.0.161
provides a detailed explanation of the command output.
Monitoring Network Events and Status
Foreign Address
0.0.0.0.0
0.0.0.0.0
0.0.0.0.0
0.0.0.0.0
Matrix E1 Series (1G694-13) Configuration Guide
Network Management
(state)
LISTEN
LISTEN
9-15