Command Defaults" Descriptions - Enterasys Matrix E1 1G694-13 Configuration Manual

Table 3-1 Factory Default Device Settings (Continued)
Device Feature
Spanning Tree transmit
hold count
Spanning Tree version.
System baud rate
System contact
System location
System name
Terminal
VLAN ID
WebView
WebView port
3.1.2

"Command Defaults" Descriptions

Each command description in this guide includes a section entitled "Command Defaults" which
contains different information than the factory default settings on the device as described in
Table 3-1. The command defaults section defines CLI behavior if the user enters a command
without optional parameters (indicated by square brackets [ ]). For commands without optional
parameters, the defaults section lists "None". For commands with optional parameters, this section
describes how the CLI responds if the user opts to enter only the keywords of the command syntax.
Figure 3-1 provides an example.
Figure 3-1 Sample Command Default Description
Command Defaults
Default Setting
Set to 3.
Set to rstp (Rapid Spanning Tree Protocol).
Set to 9600 baud.
Set to sysContact.
Set to sysLocation.
Set to sysName.
CLI display set to 80 columns and 24 rows.
All ports use a VLAN identifier of 1, and are included on the host
VLAN ID 1 port VLAN list.
Enabled.
Set at TCP port number 80.
show port status [port_string]
If port_string is not specified, status information for all ports
will be displayed.
Matrix E1 Series (1G694-13) Configuration Guide
Startup and General Configuration
"Command Defaults" Descriptions
3-3