Replacing A Raid Controller From Riser Module 1 - Fujitsu PRIMERGY RX2450 M1 Upgrade And Maintenance Manual

▶ Install the slot cover to slot 4 and fasten the screw (see circle).
Concluding steps
▶ Install the riser module 1, see
▶
"Reassembling" on page
▶
"Connecting the power cord" on page
▶
"Switching on the server" on page
9.3.3

Replacing a RAID controller from riser module 1

Upgrade and Repair Unit
(URU)
Tools: Phillips PH2 / (+) No. 2 screw driver
Preliminary steps
▶
"Locating the defective server" on page 37
▶
"Shutting down the server" on page
▶
"Disconnecting the power cord" on page
▶
"Getting access to the component" on page
▶
"Locating the defective component" on page
▶ Remove the riser module 1, see
Removing the defective RAID controller
▶ Remove the RAID controller, see
module 1" on page
Installing the new RAID controller
▶ Install the RAID controller, see
module 1" on page
RX2450 M1
"Installing the riser module 1" on page
44.
49.
37.
"Removing the riser module 1" on page
"Removing the RAID controller from riser
108.
"Installing the RAID controller in riser
106.
Upgrade and Maintenance Manual
Expansion cards and riser cards
48.
Hardware: 15 minutes
38.
39.
37.
54.
51.
109