Main memory
Figure 130: Correct position of securing clips
To improve the contact of the memory module perform the following
steps:
▶ Eject the memory module again by pressing out the securing clips at each
end of the memory slot.
▶ Press down on the memory module until the securing clips snap into the
cutouts at each end of the module.
▶ Check if all securing clips are in the correct position, see
Concluding steps
▶
"Reassembling" on page
▶
"Connecting the power cord" on page
▶
"Switching on the server" on page
162
44.
48.
49.
Upgrade and Maintenance Manual
Figure
130.
RX2450 M1