▶ Remove the cable CBL-SAST-1295-100.
▶ Cut and remove three cable ties (see blue circles).
▶ Disconnect the cable from the HDD backplane and the system board (see
orange circles).
▶ Thread the cable through the fan bracket and remove it front ward.
Please press latch of cable plug to avoid interference between the cable
plug and the fan bracket.
Figure 82: Preparation for the cable routing (C)
Figure 83: Routing the cable CBL-SAST-1257-100
▶ Disconnect plug "P2" from connector "SAS#2" on the HDD backplane.
▶ Connect plug "P2" to connector "SAS#6" on the HDD backplane.
RX2450 M1
Upgrade and Maintenance Manual
Expansion cards and riser cards
SAS#6
119