Table of Contents
Advertisement
Installing the new system board
▶ Check the settings on the new system board, see
page
215.
▶ Insert the system board by holding it at a slight angle.
▶ Lower the system board carefully into the chassis.
▶ Adjust the system board. If necessary adjust the position of the system
board with a gentle twisting motion.
▶ Fasten the system board with the nine screws, see
▶ Install the two stand-offs, see
▶
"Installing the air duct" on page
▶ Remove the heat sink with the CPU from the defective system board, see
"Removing the heat sink" on page
▶ Remove the protective plastic cover from the CPU socket of the new system
board and fit it onto the socket of the defective system board which will be
sent back to spares.
Returned system boards without this cover probably have to be
scrapped.
▶ Install the heat sink with the CPU on the new system board, see
the CPU " on page
▶ Connect all cables to the system board.
For the cable plans, see
Concluding steps
▶ Install all fans, see
▶ Install all memory modules, see
Ensure that you reinstall each memory module in the slot it was
located before the replacement.
▶ Install the AOC card and the corresponding riser card, see
new AOC card" on page
▶ Install all air ducts, see
RX2450 M1
Figure
63.
170.
175.
"Appendix B" on page
"Installing the new fan module" on page
"Installing memory modules" on page
146.
"Installing the air duct" on page
Upgrade and Maintenance Manual
System board and components
"Onboard settings" on
Figure
158.
219.
158.
"Installing
102.
160.
"Installing the
63.
197
Advertisement
Table of Contents
