Table of Contents
Advertisement
Installing the DRYER RACK
Adjusting the Squareness of the
Figure 38
DRYER RACK
981088 – September 1995
[1] Check that the tape holding the DRYER AIR
TUBES is removed. See Figure 2 on Page 6.
[2] Check that all DRYER AIR TUBES are seated
firmly in the SIDEPLATE.
[3] Manually turn the DRIVE PULLEY on the
DRYER RACK. Check that all ROLLERS turn
correctly. See Figure 39 on Page 45.
[4] Check the DRYER RACK for squareness by
placing it on a flat work surface with the TOP
COVER facing up.
Dryer
If the DRYER RACK does not sit flat on the work
Rack
surface:
(a) Loosen the SCREWS for the COVERS and
(b) Press down on the DRYER RACK until it
H130_0199ACA
(c) Tighten the SCREWS for the COVERS and
H130_0199AA
Installing the RACKS
the TIE RODS.
sits flat on the work surface.
TIE RODS.
45
Advertisement
Table of Contents
