Table of Contents
Advertisement
Unpacking the RACKS
Figure 3
O-RING
STRAP
DRIVE
SIDE
ACCESS
PANEL
[5] Remove the 2 SCREWS securing the WOOD RESTRAINT on the DEVELOPER RACK. Remove the WOOD
RESTRAINT from the DEVELOPER RACK.
[6] Remove the 2 SCREWS securing the WOOD RESTRAINT on the FIXER RACK. Remove the WOOD
RESTRAINT from the FIXER RACK.
[7] Locate the SCREW hole on the drive side of the PROCESSOR that was used to secure the WOOD
RESTRAINT onto the FIXER RACK.
[8] Install the O-RING provided into that hole using the SCREW and WASHER provided. The O-RING will be
used in later procedures to enable you to secure the COVER of the ELECTRICAL BOX in the open position.
See the figure.
[9] Remove the DEVELOPER and FIXER RACKS and any protective packing material.
[10] Cut and remove the STRAP securing the WASH RACK in place.
[11] Remove any remaining protective packing material.
981088 – September 1995
SCREW
WASHER
Unpacking the PROCESSOR
WASH RACK
FIXER RACK
SCREWS (4)
DEVELOPER
RACK
WOOD RESTRAINTS
H130_0170DCA
H130_0170DA
7
Advertisement
Table of Contents
