Table of Contents
Advertisement
Preparing the WOOD FRAME
Note
This procedure may be easier to do if you mount the WOOD FRAME to the wall before you cut the opening and drill
the holes. However, if you wish, you may cut the opening and drill the holes before you mount the WOOD FRAME
to the wall.
[34] Check that the dimensions and location of the opening cut in the wall are correct. See the figure below for the
correct dimensions.
[35] Apply lighttight CAULK to the wall around the WALL OPENING on the outside of the darkroom.
[36] Mount the WOOD FRAME securely to the wall.
[37] Cut an opening in the WOOD FRAME for the PROCESSOR. See the figure for the correct dimensions of the
hole.
[38] If there is no need for connections through the WOOD FRAME, go to section "Installing the GASKET on the
WOOD FRAME" on Page 23.
Preparing the WOOD FRAME, as viewed from the darkroom side
Figure 16
WALL OPENING
edge of the
WOOD FRAME
FRAME OPENING
for the
PROCESSOR
CAULK
WOOD FRAME
25.4 cm
(10 in.)
floor
981088 – September 1995
91.4 cm
(36 in.)
7.6 cm
(3 in.)
66.0 cm
(26 in.)
12.7 cm
(5 in.)
78.7 cm
(31 in.)
83.8 cm
(33 in.)
Installing the PROCESSOR
134.6 cm
(53 in.)
127.0 cm
(50 in.)
30.5 cm
(12 in.)
89.5 cm
(35 1/4 in.)
59.1 cm
(23 1/4 in.)
H130_0177DCB
H130_0177DA
21
Advertisement
Table of Contents
