Installing The Alternate Sprocket On An M43 Or M43A Processor Only - Kodak HEALTH SCIENCES X-Omat M43 Installation Instructions Manual

Installing the Alternate SPROCKET on an M43 or M43A PROCESSOR Only

[1] Locate the alternate SPROCKET in the bag of hardware provided.
[2] Loosen the 3 MOUNTING SCREWS securing the DRIVE MOTOR to the BRACKET. This will allow you to
slide the DRIVE MOTOR up and down in the BRACKET.
[3] Remove and save the SETSCREW from the SPROCKET on the MOTOR DRIVE SHAFT.
[4] Slide the DRIVE MOTOR up in its BRACKET as necessary to remove the DRIVE CHAIN from the
SPROCKET. If necessary for more space, remove the BRACKET from the PROCESSOR.
[5] Remove the SPROCKET.
Changing the PROCESSOR to 50 or 60 Hz Operation
Figure 28
SETSCREW
SPROCKET
DRIVE CHAIN
MOTOR DRIVE
SHAFT
MOUNTING
SCREW (3)
Note
When doing the steps below, see Figure 28 above or Figure 29 on Page 34.
[6] Install the alternate SPROCKET onto the DRIVE MOTOR.
(a) See the figures for the correct orientation of the SPROCKET.
(b) Check that the FLAT of the SPROCKET is aligned with the FLAT of the MOTOR DRIVE SHAFT.
(c) Install the SPROCKET onto the DRIVE MOTOR using the SETSCREW removed in
Step 3. Do not fully tighten the SETSCREW.
(d) Position the DRIVE CHAIN on the SPROCKET.
(e) Check that the gap between the BRACKET and the DRIVE CHAIN is approximately 0.20 cm (.080 in.).
(f) Tighten the SETSCREW.
[7] Adjust the tension of the DRIVE CHAIN as necessary, by tightening the 3 MOUNTING SCREWS loosened
in Step 2.
981088 – September 1995
Changing the PROCESSOR to 50 or 60 Hz Operation, M43 and M43A Only
50 Hz and 60 Hz
CONNECTORS
HARNESS
BRACKET
MOTOR DRIVE
DRIVE
MOTOR
SHAFT
H130_0105BCC
H130_0105BA
33