Table of Contents
Advertisement
INSTALLATION INSTRUCTIONS
Securing the PROCESSOR to the Wall
[60] If you are installing a LIGHTTIGHT FEED TRAY, see Publication Number 1C0937 for installation
instructions.
[61] Install the FRONT ACCESS PANEL onto the PROCESSOR and tighten the 2 SCREWS to secure it.
[62] Align the FEED TRAY so that it is flush with the FRONT ACCESS PANEL on the PROCESSOR.
[63] Install FEED TRAY onto the PROCESSOR using the following parts:
• 2 SCREWS
• 2 LOCK WASHERS
• 2 WASHERS
Installing the FEED TRAY
Figure 23
[64] Move the PROCESSOR and MOUNTING STAND toward the wall. Position the PROCESSOR so that the
EYEBOLTS align with the 2 holes cut in the WOOD FRAME.
[65] Slowly move the PROCESSOR and MOUNTING STAND to the wall. Insert the EYEBOLTS through the
2 holes in the WOOD FRAME.
[66] Check that:
• HOSES and POWER CABLE are not pinched
• FOAM BLOCK is compressed between the MOUNTING STAND and the WOOD FRAME for
installations where the REPLENISHMENT TANKS are located in the MOUNTING STAND
• DRAIN HOSES slope downward from the VALVE connections through the wall
28
SCREW (2)
LOCK WASHER (2)
WASHER (2)
FEED TRAY
September 1995 – 981088
H130_0084BCA
H130_0084BA
Advertisement
Table of Contents
