Kodak HEALTH SCIENCES X-Omat M43 Installation Instructions Manual page 31

Installing the KNOBS
[83] Install the KNOBS for the DRAIN VALVES by doing the steps below:
(a) Check that all 3 DRAIN VALVES are closed.
(b) Install the 3 KNOBS.
Check that you align the SETSCREW of the KNOB with the flat section of the STEM.
Leave a 3 mm (
Secure the KNOBS using the 2 SETSCREWS provided for each.
Installing the KNOBS for the DRAIN VALVES
Figure 25
[84] Install the DRYER TEMPERATURE CONTROL KNOB.
(a) Align the SETSCREW of the KNOB with the flat section of the STEM.
(b) Press the DRYER TEMPERATURE CONTROL KNOB onto the STEM of the DRYER
TEMPERATURE CONTROL.
(c) Check that the DRYER TEMPERATURE CONTROL KNOB is not touching the FRONT ACCESS
PANEL.
[85] Advance to "Doing the Water Leak Test" procedure on Page 54.
Installing the DRYER TEMPERATURE CONTROL KNOB
Figure 26
981088 – September 1995
⁄
1
in.) gap between the FRONT ACCESS PANEL and the back of the KNOBS.
8
FRONT ACCESS
PANEL
SETSCREW
(2)
KNOB (3)
STEM (3)
H130_0149ACA
H130_0149AA
Ready
Dryer
Wait
Temperature
Service
- +
DRYER TEMPERATURE
CONTROL KNOB
H130_0003ACB
H130_0003AA
Installing the PROCESSOR
31