Kodak HEALTH SCIENCES X-Omat M43 Installation Instructions Manual page 43

[5] Check:
• that the WASH MANIFOLD is inserted firmly in the water input hole in the WASH TANK.
• that the WASH RACK sits on the foam seal of the DRYER PLENUM and holds the DRYER PLENUM in
place.
• that the DRIVE GEAR of the WASH RACK engages with the MAIN DRIVE GEAR.
Note
To prevent film transport problems, press the WASH MANIFOLD down slightly to seat the WASH MANIFOLD
and the O-RING correctly in the hold.
Checking the Position of the WASH MANIFOLD
Figure 36
981088 – September 1995
WASH MANIFOLD
hole
Installing the RACKS
H130_0052BCB
H130_0052BA
43