Table of Contents
Advertisement
Installing the SPACERS on the Non-Feed End of the PROCESSOR
Figure 6
non-feed
end
REPLENISHMENT PUMP
[17] Repeat Steps 8, 9, and 12 through 16 for other end, the feed end, of the PROCESSOR.
[18] Check that the PROCESSOR is level.
[19] Install the following parts onto the 4 LEVELING FEET by reaching under the TOP of the MOUNTING
STAND:
• 4 WASHERS, provided with the MOUNTING STAND
• 4 NUTS - removed in Step 9
[20] Advance to the appropriate section as outlined below.
(a) If you are installing an M43A or Clinic 1 PROCESSOR for 60 Hz operation, advance to the section
"PROCESSOR Setup Options" on Page 35.
(b) If you are installing an M43A PROCESSOR for 50 Hz operation, advance to the section "Changing the
PROCESSOR to 50 or 60 Hz Operation" on Page 32.
981088 – September 1995
SPACER (2)
MOUNTING STAND
Installing the PROCESSOR
LEVELING
FOOT (2)
wood
support
drive side
H130_0182HCA
H130_0182HA
11
Advertisement
Table of Contents
