Table of Contents
Advertisement
INSTALLATION INSTRUCTIONS
Note
The TOP of the MOUNTING STAND has holes cut in one end to allow for the routing of HOSES and the POWER
CABLE. In through-the-wall installations, these holes must be positioned against the wall. If the
REPLENISHMENT TANKS will be stored inside the MOUNTING STAND, you must remove the TOP of the
MOUNTING STAND and rotate it 180°, as described in Step 6 below. In all other cases, you can use the
MOUNTING STAND as it was shipped.
[6] Check that the TOP of the MOUNTING STAND is positioned correctly to allow for the routing of the HOSES
and the POWER CABLE. If the REPLENISHMENT TANKS will be stored inside the MOUNTING STAND,
do the following steps.
(a) Remove the 9 SCREWS securing the TOP of the MOUNTING STAND.
(b) Rotate the TOP 180° so that the holes are at the closed end of the MOUNTING STAND.
(c) Check that the TOP of the MOUNTING STAND is flush with the closed end of the MOUNTING
STAND.
(d) Install the 9 SCREWS in the second set of pre-drilled holes on the under side of the TOP of the
MOUNTING STAND.
Rotating the TOP of the MOUNTING STAND
Figure 10
TOP
16
ROTATE 180
holes
closed
end
SCREW (9)
MOUNTING
STAND
side
wall
H130_0205HCA
H130_0205HA
September 1995 – 981088
Advertisement
Table of Contents
