Kodak HEALTH SCIENCES X-Omat M43 Installation Instructions Manual page 23

Installing the GASKET on the WOOD FRAME
[41] Cut the foam GASKET to fit around the edges of the hole cut in the WOOD FRAME for the PROCESSOR.
[42] Install the GASKET on the PROCESSOR side of the WOOD FRAME around the perimeter of the hole. See
the figure for the correct location of the GASKET.
[43] Check that there are no gaps in the GASKET.
[44] Cut another piece of GASKET the dimension of the front of the PROCESSOR.
[45] Install the GASKET on the PROCESSOR along the bottom edge of the FRONT ACCESS PANEL.
Important
Additional GASKETS may be necessary in some installations:
• where the wall is not plumb
• if using a LIGHTTIGHT FEED TRAY
Installing the GASKETS
Figure 18
FRONT ACCESS
PANEL
981088 – September 1995
Installing the PROCESSOR
GASKETS
WOOD FRAME
Position
of
GASKET
when
installed
H130_0197HCA
H130_0197HA
23