Table of Contents
Advertisement
INSTALLATION INSTRUCTIONS
Inserting the INTERLOCK TOOL into
Figure 49
the AC INTERLOCK SWITCH S5
INTERLOCK
SWITCH
INTERLOCK
TOOL-4740
[18] Feed two 35 x 43 cm (14 x 17 in.) sheets of pre-processed or cleanup film.
(a) Check that the REPLENISHMENT PUMP energizes.
(b) Check that the WATER INPUT SOLENOID opens to replenish the WASH TANK.
(c) Check that the WASH PUMP starts pumping water into the WASH TUBES within 60 seconds from the
time you block a FILM SENSOR.
(d) Check that the transport system is operating correctly by checking that the films exit the PROCESSOR
and drop into the RECEIVE BIN within approximately 130 seconds after they were fed.
Note
Depending on the current state of the PROCESSOR:
• the WAIT INDICATOR may blink or may not blink
• the film feed signal may beep multiple times
[19] If the PROCESSOR is not at the "Ready State," wait 10 - 45 minutes, depending on the temperature of the
water, for the READY INDICATOR to remain illuminated.
56
[13] Insert the INTERLOCK TOOL TL-4740 into the
AC INTERLOCK SWITCH S5, located near the
DRYER ASSEMBLY on the drive side of the
PROCESSOR.
[14] Place a MAGNET onto the DC INTERLOCK
SWITCH S6 on the DRYER PLENUM
BRACKET.
[15] Energize the PROCESSOR by moving the MAIN
CIRCUIT BREAKER CB1 to the "1" position.
[16] Check that:
[17] Check that:
H130_0027ACA
H130_0027AA
The DEVELOPER TEMPERATURE DISPLAY on an
M43 or M43A PROCESSOR will not display a
temperature reading until the developer temperature
reaches a minimum of 24°C (75°F).
• GEARS turn
• ROLLERS turn
• RACKS remain seated in place
• RECIRCULATION PUMPS energize
– look for movement on the surface of the
solutions in the DEVELOPER and
FIXER TANKS
• DRYER BLOWER energizes
• WATER INPUT SOLENOID opens to
replenish the WASH TANK
– wait 3 minutes for the WASH TANK to
fill partially before doing the next step
Note
September 1995 – 981088
Advertisement
Table of Contents
