Removing The Scanner Cover; Installing The Scanner Cover - Kodak CR 360 Service Manual

Removing the Scanner Cover

[1] Switch OFF the scanner.
[2] With the system upright, pull the scanner to the edge of the table so that the front side is extended slightly over
the table edge.
[3] Remove the 2 scanner cover screws using a 5 mm Allen wrench.
[4] Remove the 2 scanner cover screws at the back of the scanner (one on each side) using a 5 mm Allen wrench.
[5] Lift off the cover.

Installing the Scanner Cover

[1] Check (in this order):
a. The scanner is switched OFF.
b. The safety interlock key is not in the interlock.
c. The laser board DIP switch is switched ON.
[2] Install the scanner cover.
[3] Install the 4 scanner cover screws.
[4] Switch ON the scanner.
6H4869
Service Procedures
Scanner
cover
screws
25