Table of Contents
Advertisement
INSTALLATION INSTRUCTIONS
[5] Install the DRYER RACK on top of the WASH RACK. See the figure below.
(a) Align the non-drive side of the DRYER RACK first.
(b) Check that all GEARS engage correctly.
(c) Check that the DRYER RACK seats correctly on the DRYER PLENUM.
(d) Check that the SIDEPLATES of the WASH RACK are flush with the SIDEPLATES of the DRYER
RACK.
(e) Check that the TABS on both sides of the WASH RACK engage the SIDEPLATES of the DRYER RACK
correctly. See the figure below.
[6] If you are installing the PROCESSOR through the darkroom wall, go to section "Securing the PROCESSOR"
on Page 28. If not, continue with Page 47.
Installing the DRYER RACK
Figure 39
TAB on
DRYER
WASH RACK
RACK
46
DRIVE PULLEY
SIDE PLATE
SCREW
(8)
DRYER RACK
COVER
September 1995 – 981088
non-drive
side
H130_0148HCA
H130_0148HA
Advertisement
Table of Contents
