Chapter 2: Installation
Page 2-8
Procedure: Connecting
Additional Units to the
Switch
L2 ADAPTER
1
2
3
4
FIGURE 2-5
Connecting the L2 Adapter Harness to the B25 Cable
Plug a D8W connector from the L2 adapter harness into
b
the connector on the rear of each new HSL labeled
LINE, and then skip to the section, Installing DC and
AC Power Cords, later in this chapter.
Note:
If you are using individual D8W cords (attribute 6):
2
Plug one end of a D8W cord into the connector on the
a
rear of the HSL labeled LINE.
Plug the free end of the D8W cord into the assigned
b
wall jack.
Use the same procedure for connecting each new unit
c
to the switch, and then skip to the section, Installing
DC and AC Power Cords, later in this chapter.
Existing Installation
The following procedure is for connecting additional units in an
existing data mounting to the switch.
DEFINITY
B25 Connector
B25 Cable
from Switch
Numbers labeling the D8W connectors should
correspond to slot numbers on the Z77A Data
Mounting.
Communications System
DEFINITY High Speed Link
User´s Guide