Avaya 6424D+M User Manual page 93

DEFINITY Communications System
DEFINITY High Speed Link
User´s Guide
Appendix D: Applications and Switch Administration
Trunk Group Administration
To administer Trunk Group 60 to carry SDN/SDDN traffic the
following procedures must be performed:
PROC 260 Word 1 is used to administer the DS1 circuits with
signaling. This is only required if the DS1 in which the trunk
group is to be administered on has not yet been administered.
PROC 100 Word 1 (Screen D-6) is used to administer the trunk
group translations. To implement this application, the
following fields must be populated.
Field 1 (Trunk Group): 60. This is the trunk group
number for this application.
Fields 2-5 (Dial Access Codes): 160. 160 is used in this
application.
Field 6 (Trunk Type): 41. Although a trunk type of 41
indicates a TIE ETN 2-way dial repeating trunk group, it
can also be used to indicate dynamic access.
PROC 100 Word 2 is used to define the BCCOS of the trunk
group. To allow voice and 56 Kbps (Mode 1) data calls on the
same trunk group, Field 2 (BCCOS) should be set to "3," the
default BCCOS for administering alternate voice/data trunk
groups. This procedure should be performed only if the call is
going to be routed over ISDN PRI facilities.
PROC 101 Word 1 is used to administer trunk group
characteristics. To enable touch-tone signaling for incoming
and outgoing trunks, Fields 6 and 7 should be set with a "1" for
trunk group 60.
Page D-19