Routing - Avaya 6424D+M User Manual

Appendix D: Applications and Switch Administration
Page D-22

Routing

For the Generic 2 to dynamically route video and voice calls over
a dynamic trunk group, it needs to know if the destination is a
video endpoint. This is done using pseudo PBX location codes
(RNXs) as already described in the Generic 1 administration. In
this example, the Generic 1 has an RNX of 331. A pseudo RNX of
330 will be created so that the Generic 2 will know when to insert
the "115" and which trunk group to use. To do this the following
steps should be taken:
PROC 321 Word 1 (Screen D-8) is used to administer AAR for
routing and digit manipulation instructions and should be
populated as follows:
Field 1 (AAR Pattern Number): 30. This identifies the
routing pattern to be used.
Field 2 (Preference Number): 1. This should be first
preference used for routing.
Field 3 (Trunk Group): 60. Trunk Group 60 will be used to
carry voice and video calls to SDN/SDDN.
Field 7 (Digits Deleted): 3. Three digits will be deleted for
these calls. In this case, it will be the pseudo RNX 330.
ENHANCED MODE - PROCEDURE:
1. Pattern Number: [30]
2. Preference Number: [1]
3.
4. Facility Restriction Level: [-]
5.
6.
7. Number of Digits Deleted: [3]
8. Digit Collect (DC) Signal Ignore: [-]
9.
10. IXC ISDN Network Identifier: [---]
Generic 2 Routing Administration - AAR Routing
DEFINITY
DEFINITY High Speed Link
321, WORD:1
AAR - ROUTE TABLES
Trunk Group: [60]
Warning Tone: [-]
Off Net: [-]
Oxxx Allowed: [-]
SCREEN D-8
Communications System
User´s Guide