Dsc Administration - Avaya 6424D+M User Manual

Appendix D: Applications and Switch Administration
Page D-40
Generic 2 in this new configuration is the same as previously
described.
To establish a PSC between extension 5000 on the Generic 1 and
extension 3000 on the Generic 2 requires station, trunk, and PSC
administration. Station and trunk administration will be the same
as described previously for the Generic 3. PSC administration is
performed using the Permanent Switched Call form in the
following manner:
In the column under Originator, 5000 should be entered.
In the column under Destination, 110,3000 should be entered.
110 is the TAC to the Generic 2, the comma inserts a delay, and
3000 is the destination extension on the Generic 2.
In the column under Enabled, y should be entered to originate
and maintain the call.
With this administration, the Generic 1 will originate the call from
the FEP (extension 5000) to extension 3000 on the Generic 2 and
maintain the connection until it is taken down.

DSC Administration

To describe how DSC administration is done, consider the same
example, except with the Generic 3 replaced by a Generic 2 or a
System 85. Unlike a PSC, a DSC can support a connection to an
access endpoint and to another switch, but requires a DSC to be
set up on both switches. This section will describe how a DSC is
administered for this application.
In this example, a DSC is to be established on the Generic 2 with
the FEP between extension 5000 and the DS0 channel that will be
used to connect to the other Generic 2. Establishing this
connection requires station, trunk, and DSC administration.
Station and trunk administration will be the same as described
previously for a Generic 2 permanent connection. DSC
administration is accomplished in the following manner:
PROC 000 Word 3 administers a code for a "dedicated mode"
message used with some data modules. Since the HSL does
not support this message, Field 3 should be populated with a
"0."
PROC 360 Word 1 administers a DSC between two line or
trunk ports and the fields should be populated in the following
manner:
Field 1 (DSC Status). A "1" should be entered to indicate
on, and a "0" to indicate off.
Field 2 (DSC Number). This is the number used to
identify this DSC (0-1023).
DEFINITY Communications System
DEFINITY High Speed Link
User´s Guide