Procedure: Connecting The Cables - Avaya 6424D+M User Manual

DEFINITY Communications System
DEFINITY High Speed Link
User´s Guide
Procedure: Connecting the
Cables
The HSL powers on as soon as the AC cord of the
power supply is connected to a live AC power outlet.
The HSL displays the following messages on the front
panel as it performs its startup self-test.
SELF TESTING
SELF-TEST PASSED
REL 1.0, VER 1.0
IDLE
If everything is normal, the HSL dispays the IDLE
message. Should the HSL fail self-test, the system
displays different messages than what is shown above.
If this happens, refer to the Self-Test section in Chapter
3, ''Using the Front Panel.''
Use the following procedure for connecting cables between the
new units and their associated terminals or ports on the terminal
equipment.
Connect one end of a V.35 cable to the connector on the rear
1
of the HSL labeled V.35, and tighten the connector retaining
screws.
If RS-366/RS-232 dialing is to be used, connect one end of
2
the RS-366/RS-232 cable to the connector marked RS-
366/RS-232, and tighten the retaining screws.
Dress the cable(s) toward the rear of the cabinet, through the
3
associated plastic twist lock at the rear of the Z77A Data
Mounting, and twist the top ends of the lock to secure the
cable
(see Figure 2-7).
Chapter 2: Installation
Page 2-11