Installing Dc And Ac Power Cords; Procedure: Attaching Power Cords - Avaya 6424D+M User Manual

DEFINITY Communications System
DEFINITY High Speed Link
User´s Guide
Installing DC and
AC Power Cords
Procedure: Attaching
Power Cords
If your installation uses the L2 adapter harness, plug a D8W
1
connector from the L2 adapter harness into the connector on
the rear of each new HSL labeled LINE, and then skip to the
section, Installing DC and AC Power Cords later in this
chapter.
Note: Numbers labeling the D8W connectors should
correspond to slot numbers on the Z77A Data
Mounting.
If your installation uses individual D8W cords:
2
Plug one end of a D8W cord into the connector on the
a
rear of the HSL labeled LINE.
Plug the free end of the D8W cord into the assigned
b
wall jack.
Use the same procedure for connecting each new HSL
c
to the switch, and then proceed to the section,
Installing DC and AC Power Cords, later in this
chapter.
The following procedure is for attaching DC power cords to units
in new or existing installations, and for connecting the AC power
cord to a newly installed Z77A Data Mounting.
CAUTION: Do NOT disconnect the AC power of a Z77A
data mounting if you are installing additional
units to an existing data mount. Disconnecting
the AC power will interrupt data connections on
the other units in the rack.
(All installations) Insert one of the loose DC power cords
1
from the data mounting power supply into the connector
labeled POWER on the rear of each unit being installed.
(New or disconnected data mounting) Install the AC power
2
cord as follows:
Plug one end of the AC power cord into the AC
a
connector at the rear of the data mounting power
supply (Figure 2-6).
Chapter 2: Installation
Page 2-9