Table of Contents
Advertisement
Intel® Server System M50CYP2UR Family System Integration and Service Guide
3.13.1
Intel® RMFBU Mounting Bracket Installation
The RMFBU mounting bracket can be installed in the same area inside the chassis as the midplane card or
SAS interposer card (see
side and right side).
Figure 91. Intel® RMFBU Mounting Bracket Installation - Chassis
Figure 92. Intel® RMFBU Mounting Bracket Installation - Air Duct
1.
Power off the system and disconnect the power cable(s).
2.
Remove the system top cover (see
3.
Remove the air duct (see
4.
Remove the cable clip, if installed, by unfastening the two screws holding the clip to the chassis.
5.
Align the two screw holes of the RMFBU mounting bracket with the matching threaded holes on the base
of the chassis or on the top of the air duct (see Letter A).
6.
Secure the RMFBU mounting bracket to the chassis or to the air duct using two screws (see Letter B).
Tighten to 5 in-lb.
7.
Slide the RMFBU assembly in the direction as indicated on the mounting bracket (see Letter C) until the
latch locks in place.
8.
Attach all the connectors as required.
9.
Reinstall the air duct (see
10. Reinstall the system top cover (see
80
Section 3.8
or 3.11). Or, it can be installed on top of both sides of the air duct (left
Section
Section
3.2.1).
Section
3.2.2).
Section
3.1.1).
3.1.2).
Advertisement
Table of Contents
