2.5" Ssd Drive Assembly For 7 Mm Drives; Figure 46. Separating Top And Bottom Parts Of Drive Blank; Figure 47. Attaching The Drive Blank To 7 Mm Ssd - Intel M50CYP2UR Series System Integration And Service Manual

Intel® Server System M50CYP2UR Family System Integration and Service Guide
3.4.1

2.5" SSD Drive Assembly for 7 mm Drives

The Intel® Server System M50CYP2UR family supports 2.5" SSDs with 7 mm of thickness when used in
conjunction with the supplied blanks. The supplied blank for 2.5" bays has two parts: top and bottom. The
top part must be attached to the 7 mm drive to fit properly inside the 2.5" bay. This section provides
instructions to attach the supplied blank part to a 7 mm thick SSD.
1. Remove the drive blank from the system (see
2. Press the handles at the bottom part of the drive blank (see Letter A).
3. Separate the top and bottom parts while pressing the handles (see Letter B).
4. Insert the 2.5" 7 mm SSD drive into the top part of the drive blank as shown in the above figure.
Caution: To avoid damaging the SSD connector, insert the drive into the supplied blank in the direction
shown.
With the supplied blank attached to the drive, it can be installed as a regular 2.5" SSD drive.
50

Figure 46. Separating Top and Bottom Parts of Drive Blank

Figure 47. Attaching the Drive Blank to 7 mm SSD

Section 3.4.3).