Phm And Processor Installation; Figure 129. Processor Removal From Phm Assembly; Figure 130. Processor Carrier Clip Removal From Phm Assembly - Intel M50CYP2UR Series System Integration And Service Manual

Intel® Server System M50CYP2UR Family System Integration and Service Guide
10. Place the PHM, bottom side up, on a flat surface.
11. While holding down the PHM, rotate the lever (see Letter A) from left to right until the processor lifts
from the processor carrier clip.
12. While holding the processor carrier clip, carefully lift the processor and slide it out of the processor
carrier clip (see Letter B).

Figure 130. Processor Carrier Clip Removal from PHM Assembly

13. Return the lever to the original position (see Letter C).
14. Unlatch the tab on each corner of the processor carrier clip and lift the clip up to remove the processor
carrier clip from the heat sink (see Letter D).
6.7.2

PHM and Processor Installation

To properly assemble the PHM and install it to the server board, the procedures described in the following
sections must be followed in the order specified. These instructions assume that all the PHM components
are new and the Thermal Interface Material (TIM) is already applied to the bottom of the heat sink.
6.7.2.1 Processor Heat Sink Module (PHM) Assembly
Caution: Wear ESD gloves to prevent electrostatic damage and oxidation or foreign material on processor
package and land pads.
Note: The label on the heat sink refers to PHM installation onto the server board. It does not refer to the
PHM assembly process.

Figure 129. Processor Removal from PHM Assembly

103