Advertisement
bizhub C4000i/C3300i
3. Select a model in [Model].
4. Select a preset pattern or marketing area in [Preset]. (The number of functions displayed in the Function list below decreases in the order
of Full > Standard > Basic.)
5. Select whether items should be displayed (ticked) or hidden (unticked) in [Function]. (Make this setting both in the Copy tab and the Scan/
Fax tab.)
6. Save the setting file (CPD file) with one-byte alphanumerics and symbols in [Save as...].
<Edit an existing setting file>
1. Start up the Panel Customization Tool.
2. Select a model in [Model].
3. Select an existing setting file (CPD file) in [File] -> [Open].
4. Select whether items should be displayed (ticked) or hidden (unticked) in [Function].
5. Save the setting file (CPD file) with one-byte alphanumerics and symbols in [Save as...].
Importing setting file (CPD file)
1. Copy the setting file (CPD file) to the root directory of a USB memory.
2. Connect the USB memory to the USB port of the MFP.
3. Touch [Custom Pattern].
4. Select [Custom Pattern 1], [Custom Pattern 2] or [Custom Pattern 3].
5. Touch [Import] to select the data to be imported.
6. Press Start Key to import the data.
7. Select the registered custom pattern in [Administrator] -> [System Settings] -> [Custom Function Pattern Selection].
NOTE
▪ To delete registered data, select the target Custom Display Pattern from the [Administrator] -> [System Settings] -> [Custom
Function Pattern Selection], touch [Delete] -> [Fix] and check that the result "OK" appears.
10.19 Maintenance Mode
• The authentication procedure to log on to Administrator Settings or Service Mode is canceled during setup or setup change to thereby
achieve a shorter operating time.
• The following functions are enabled.
• The Administrator password is skipped (there is no need to enter the password)
• The CE password is skipped. (there is no need to enter the CE password)
• Import/export setting can be displayed even without the setting made for switch number "72" of the Software Switch Setting.
• A bar appears in the upper row of the control panel in the Maintenance Mode.
NOTE
▪ To enable the maintenance mode, set [Administrator] -> [Security] -> [Security Details] -> [Maintenance Mode Access] -> to
[Allow].
Setting item
Maintenance Mode
Display language
Job History Clear Upon Job
Completion
<Exiting the Maintenance Mode>
• To exit the Maintenance Mode, select [Service Mode] -> [System 2] -> [Maintenance Mode] and touch [Invalid], or touch the arrow key on
the control panel and select [Yes] from the confirmation screen.
10.20 Smart Fusing Control
• Specifies whether or not to apply low power fusing control.
Setting value
Permit
Applies low power fusing control by lowering the target temperature as much as possible in response
to the single sheet data. In this way, the power consumption (TEC value) is controlled.
Prohibit
Controls the adjustment of the specified fusing temperature.
10.21 Cleaning Unit Setting
• Use this feature upon the optional clean unit set-up.
Installed
Not Installed
10.22 Fuser roll deform
• Rotates the fusing belt to prevent the same fusing belt surface from being left alone for long periods of time in order to prevent deformation.
• Prevents unevenness in gloss caused by fusing belt deformation.
Setting value
Detail
OFF
-
Set whether to enable or disable the Maintenance Mode.
Select the language to be displayed in the Maintenance Mode. When
[Not Set] is selected, the displayed language is that valid before the
machine enter the Maintenance Mode.
Set whether to erase the past job history and the job history during the
Maintenance Mode.
Setting value
Contents
Contents
I-40
I SERVICE MODE > 10. System 2
Setting value
Default setting
Invalid
Effective
Not Set
Display
language
Set
Unset
Default setting
Default setting
○
Default setting
○
○
○
○
○
Advertisement
