Advertisement
bizhub C4000i/C3300i
9.7 Warm-up
9.7.1 Change Warm Up Time
• To change warm up completion time.
• Mode is changed to Mode 2 in case the paper gets curled significantly when black printing is conducted immediately after warm up at Mode
1.
• Mode is changed to Mode 3 or 4 in case the paper gets curled immediately after normal warm up or the curled paper causes paper jam,
paper exit failure, punch/staple/fold position failure or etc.
Setting item
Mode 1
It makes the warm-up time for black print shortest.
Mode 2
The warm-up time for both black and color will be as specified value.
Mode 3
To prevent curling of the paper immediately after the warm-up, printing productivity is decreased by
PPM control.
The warm-up time for both black and color will be as specified value.
Mode 4
By having a longer warm-up time and warming up the fusing unit, curling of the paper immediately after
the warm-up can be prevented.
Fusing operation mode
• Warm-up related control can be changed by using [Warm Up] setting and
DipSW.
When the main power switch is turned on, the mode is defined according to each choice setting.
• The following table shows the features of each operation mode.
9.8 Burn Prevention Settings
• To prompt to prevent a burn injury by displaying a message indicating that the fusing unit is at a high temperature when the right door has
to be opened in order to get rid of a paper jam.
Enable
Disable
Setting item
Contents
[Choice of high humidity circumstance] setting in Engine FW
I-28
I SERVICE MODE > 9. System 1
Default setting
Default setting
○
○
Advertisement
