Ricoh Pro C901 Technical Bulletin page 88

Reissued: 07-Aug-2012
Model:
Aries-P1.5/C1.5
12"x18"
Y: 343 mm from leading edge (3
M: 93 mm from leading edge (3
C: 415 mm from leading edge (2
K: 165 mm from leading edge (2
13"x19"
Y: 343 mm from leading edge (3
M: 93 mm from leading edge (3
C: 415 mm from leading edge (2
K: 165 mm from leading edge (2
Action
1. Install 2 modified fly wheels (P/N: M0771294) in between the mainframe and the default
fly wheel, so that a total of 3 fly wheels are installed per station. Secure the fly wheels
with TAPPING SCREW:4X12 (P/N: 04514012N) (x3). See "Installing the Modified Fly
Wheels" for the detailed procedure.
2. Apply the following firmware versions.
Web Support
Engine
System/Copy
3. Change the following SP values:
SP
SP2-992-001
SP2-993-001
4. Enter the Adjustment Settings for Skilled Operators menu and adjust the main
scan starting point in "0101: Adjust Image Position With Feed Direction" for both
front and back sides to compensate for the image position shift as a result of the
SP modification in the previous step.
If the results are accepted by the customer, the procedure is complete.
If the results are not accepted by the customer, do the following step.
5. Register the paper that is now being used into the Paper Library.
T
echnical
rd
page and later)
rd
page and later)
nd
page and later)
nd
page and later)
rd
page and later)
rd
page and later)
nd
page and later)
nd
page and later)
Part number
D0956083
D0955253
D0956081
Modified Default
0.5 0
1 0
B
ulletin
Date:
18-Feb-11
Version
1.03
1.007:16
1.05
Remarks
Drum process speed increases 0.5% and
becomes level with the ITB rotation speed.
As a result, the main scan starting point
shifts approx 0.75 mm towards the leading
edge on both sides of the paper.
Image position must be readjusted in the
Adjustment Settings for Skilled Operators
menu to compensatefor the shift.
Cut-off frequency for drum revolution
control is reduced from 30Hz to 13Hz to
prevent resonance vibration.
PAGE: 8/28
No.:
RM077019g