Ricoh Pro C901 Technical Bulletin page 159

Model:
Aries-P1.5/C1.5
Step A-5. "D4477578: SHEET*SHIFT TRAY: INNER BACK"
The Mylar is attaxhed to 3 separate sheets divided by slits. Peel off only the 'Center' sheet.
Step A-6. Keep in mind the corner indicated 'B' as a reference point, and attach the 'Center' part of the Mylar
to the tray so that all edges of the Mylar are positioned 2mm inside the edges of the tray.
The Mylar MUST be positioned
correctly in this area.
Step A-7. Peel off both 'Top' and 'Bottom' sheets and slowly attach the Mylar outward from the center.
Make sure the edges far from the reference point 'B' also do not protrude against the line.
Attach in a "top-to-bottom"
direction to avoid air-bubbles
on the sloping part.
Step A-8. Finally, rub the Mylar entirely for complete attachment.
NOTE
1. Attach the Mylar slowly to avoid air-bubbles between the Mylar and the
tray.
2. The Mylar must be attached in one attempt.
Do NOT peel off and reattach the Mylar to correct the position.
The position should be well adjusted before actually attaching the Mylar.
T
echnical
Top
2mm
B
ulletin
Date:
15-Jun-11
Slit
Center
2mm
B
PAGE: 7/39
No.:
RM077037
Slit
Bottom
The Mylar MUST be
positioned correctly
in this area.