Ricoh Pro C901 Technical Bulletin page 160

Model:
Aries-P1.5/C1.5
Step A-9. "D4477581:SHEET*SHIFT TRAY*FRONT"
The Mylar is attached to 3 separate sheets divided by slits. Peel off only the 'Center' part.
Step A-10. Keep in mind the corner indicated 'C' as a reference point, and attach the 'Center' part of the
Mylar to the tray so that all edges of the Mylar are positioned 2mm inside the edges of the tray.
The Mylar MUST be
positioned correctly in
this area
Step A-11. Peel off both 'Top' and 'Bottom' sheets and slowly attach the Mylar outward from the center.
Make sure the edges far from the reference point 'C' also do not protrude against the line.
Attach in a "top-to-bottom"
direction to avoid air-bubbles
on the sloping part.
Step A-12. Finally, rub the Mylar entirely for complete attachment.
NOTE
1. Attach the Mylar slowly to avoid air-bubbles between the Mylar and the
tray.
2. The Mylar must be attached in one attempt.
Do NOT peel off and reattach the Mylar to correct the position.
The position should be well adjusted before actually attaching the Mylar.
T
echnical
Top
B
ulletin
Date:
15-Jun-11
Center
Slit
2mm
C
2mm
PAGE: 8/39
No.:
RM077037
Bottom
Slit
The Mylar MUST be
positioned correctly in
this area