Switch Hardware And Software Requirements - Nortel T1/SMDI Configuration Manual

Configuring the switch
Switch hardware and software
requirements
Hardware components
The hardware components required depends on the switch type in your
installation. For more information on hardware components and the T1/
SMDI interface, see:
Chapter 3, "Connecting the CallPilot server to the switch," on page 31
for CallPilot SMDI and T1 hardware components
Appendix A, "CallPilot T1/SMDI interfaces," on page 153 for the
CallPilot T1/SMDI interface
I/O port
If you are using an SL-100 or DM-100 switch you must have either an IOC
shelf with an NT1X89 card or an IOM (NTFX30AA) to support the SMDI
link to CallPilot.
Switch software version required for CallPilot
The SL-100 switch requires SL10 or higher.
The DMS-100 switch requires NA08 or higher.
Required Patches
If patches are required, this information is provided in the CallPilot
Distributor Technical Reference (DTR) available at
http://www.nortel.com/pic (the web site URL can vary by region). You
require a username and password to access this site.
54
Standard 1.13
CallPilot