Alcatel-Lucent 7330 Product Information Manual page 87

At the subscriber premises, the business ONT terminates DS1 or E1 links from the
subscriber. The TDM traffic is adapted and packetized using MEF-8 pseudo-wire
technology before being transported across the GPON. MEF-8 is the payload option
that is used. The MEF-8 packets are multiplexed with the Ethernet layer 2 data traffic
at the business ONT GPON port.
When the MEF-8 packets are received at the OLT, the packets are forwarded to the
destination PSTN, typically via a voice gateway that is connected to the IP network.
Figure
Figure 3-2 CES DS1 or E1 traffic between the ONT and PSTN over the GPON via the OLT
DS1 or E1
Voice gateway
Class 5 PSTN
switch
CES clocking and synchronization
The same clocking reference at both ends of the DS1 or E1 link is required to meet
the wander requirements of TDM traffic.
The business ONT can use one of two clocking sources for CES:
•
a derived GPON clock at 16.384 MHz
•
a 6.384 MHz local oscillator.
When the system clock for CES is derived from the GPON, the upstream P-OLT
locks to the BIT clock and supplies the ONT with an Ethernet clock that is traceable
to a network timing reference. The supplied Ethernet clock is used for differential
clock recovery and for timing the upstream pseudo-wire MEF-8 packet streams in
the absence of a valid TDM recovery clock. The local oscillator is only used if
adaptive mode is selected.
The downstream TDM streams may be timed from one of two clocking sources:
•
a 16.384 MHz adaptive clock received from the MEF-8 packet stream.
•
a differential clock recovered from the MEF-8 packet stream via the GPON.
When the clock is received from the GPON, the GPON must be configured to send
RTP packets.
Alcatel-Lucent 7330/7302 ISAM FTTN R04.02.41
3FE 54017 AAAA TCZZA
3 — ONT and MDU general and interface technical specifications
3-2 shows the traffic flow.
EMS
L2
GE Ethernet
cloud
DHCP server
December 2010
Edition 01 ONT Product Information Guide
GE GPON
OLT
DS1 or E1
Business
ONT
3-11