Alcatel-Lucent 7330 Product Information Manual page 223

NTP 121 — Install an I-241G-A indoor ONT
Safety information
Read the following safety information before installing the unit.
Procedure
Use this procedure to install an I-241G-A indoor ONT.
1
2
NTP 121-2
Danger 1 — Always contact the local utility company before you
connect the enclosure to the utilities.
Danger 2 — Observe the local and national laws and regulations that
may be applicable to this installation.
Warning — This equipment is ESD sensitive. Proper ESD protections
should be used when removing the fiber access cover of the indoor ONT.
Caution — Keep indoor ONTs out of direct sunlight. Prolonged
exposure to direct sunlight can damage the unit.
Note — Observe the following:
The indoor ONT should be installed in accordance with the
•
applicable requirements of the NEC or CEC. Local authorities and
practices take precedence when there is conflict between the local
standard and the NEC or CEC.
The indoor ONT must be installed by qualified service personnel
•
only.
Indoor ONTs must be installed with cables that are suitably rated
•
and listed for indoor use.
Prepare the cables at the site where the ONT will be installed (DLP 100).
Review the connection locations shown in Figure
December 2010
ONT Product Information Guide Edition 01
NTP 121-1.
Alcatel-Lucent 7330/7302 ISAM FTTN R04.02.41
3FE 54017 AAAA TCZZA