Alcatel-Lucent 7330 Product Information Manual page 194

5 — ONT management using an ONT interface
4
5
6
7
8
Procedures using HTTP interface for Package C ONTs
The following procedures provide the steps to view the current SLID settings and to
enter a new SLID at the ONT using the HTTP interface for Package C ONTs.
Procedure 5-44 To view current SLID settings
1
5-62
Perform one of the following to enter the SLID value in alphanumeric or
hexadecimal format:
a In alphanumeric format, enter the SLID up to 10 ASCII characters of 0 to 9, a
to z, or A to Z.
b In hexadecimal format, enter the SLID up to 20 characters of 0 to 9, a to f,
or A to F, with zeroes appended to a length of 20 characters.
Choose option 4, Retrieve SLID, to verify that the SLID was entered correctly.
Perform one of the following to connect the ONT to the PON:
a If the ONT is disconnected from the PON, connect the PON optical cable to
the ONT.
b If the ONT is connected to the PON, disconnect, and then reconnect the PON
optical cable.
Perform one of the following to provision the ONT and services:
a If the ONT and services were preprovisioned at the P-OLT, the P-OLT will
automatically range and provision the ONT, after the ONT is connected to the
PON optical cable.
b If the ONT and services were not preprovisioned at the P-OLT, notify the TL1
or network manager GUI operator to provision the ONT and services at the
P-OLT using SLID.
STOP. This procedure is complete.
Note —
To enter or clear a SLID using an Ethernet connection, the
ONT must be disconnected from the PON optical cable.
Select the SLID option from the ONT Admin section of the navigation tree in the
GPON ONT window.
The SLID window appears; see Figure 5-37.
December 2010
ONT Product Information Guide Edition 01
Alcatel-Lucent 7330/7302 ISAM FTTN R04.02.41
3FE 54017 AAAA TCZZA