Alcatel-Lucent 7330 Product Information Manual page 196

5 — ONT management using an ONT interface
2
3
4
Procedures using CLI interface for Package C ONTs
The following procedures provide the steps to retrieve the current SLID and to
modify the SLID using the CLI interface provided with Package C ONTs.
Procedure 5-46 To retrieve the current SLID settings
1
2
Procedure 5-47 To modify the SLID
1
2
5-64
Perform one of the following to enter the new SLID value in alphanumeric or
hexadecimal format in the Input New SLID field:
a In alphanumeric format, enter a numeric string of up to 10 characters.
b In hexadecimal format, enter a numeric string of up to 20 characters. The
string must be prefixed with a zero.
Press Apply.
STOP. This procedure is complete.
Note —
To enter or clear a slid:
•
If you are using an Ethernet connection, the ONT must be
disconnected from the PON optical cable.
•
If you are using a craft connection, the ONT can be connected or
disconnected from the PON optical cable. However, if you modify
the SLID with the ONT connected to the PON optical cable, the
data at the ONT is not changed; the data at the ONT is only
changed after the ONT reranges. Rerange the ONT by
disconnecting and reconnecting the PON optical cable, which
generates a NEWONT alarm.
Type S or s for Retrieve SLID from the
The system displays the current SLID in string format. The SLID settings are
described in Table 5-10.
STOP. This procedure is complete.
Type M or m for Modify SLID from the
Perform one of the following to enter the new SLID value in alphanumeric or
hexadecimal format:
a In alphanumeric format, enter a numeric string of up to 10 characters.
b In hexadecimal format, enter a numeric string of up to 20 characters. The
string must be prefixed with a zero.
December 2010
ONT Product Information Guide Edition 01
SLID menu.
SLID menu.
Alcatel-Lucent 7330/7302 ISAM FTTN R04.02.41
3FE 54017 AAAA TCZZA