Alcatel-Lucent 7330 Product Information Manual page 186

5 — ONT management using an ONT interface
2
3
4
5
6
Procedures using CLI interface for Package C ONTs
Not applicable.
Procedures using butt set
Not applicable.
5.14 Activating an ONT using an SLID
The P-OLT is programmed to use the serial number or a SLID to activate a newly
polled ONT on the PON with its provisioning data and services. The serial number
is hard-coded into the ONT; the SLID is a hexadecimal or alphanumeric string that
you enter locally into the ONT to uniquely identify the ONT on the PON.
After the P-OLT polls the PON for new ONTs, the ONT sends its SLID, range, and
registration information to the P-OLT. The P-OLT matches the ONT with its
provisioning data and services in the P-OLT database, using the serial number or the
SLID. When a database match is found, the P-OLT downloads the provisioning data
and services to the ONT, and the ONT and its services are activated.
5-54
Figure 5-31 Protocol Trace window
Select a tracing protocol by choosing either ARP, DHCP, or IGMP.
Click Start to initiate a protocol trace.
If necessary, click Stop to end a protocol trace.
Perform one of the following tasks with the tracing file produced by the protocol
trace.
i Click Download to save the tracing file.
ii Click Delete to delete the tracing file.
STOP. This procedure is complete.
December 2010
ONT Product Information Guide Edition 01
Alcatel-Lucent 7330/7302 ISAM FTTN R04.02.41
3FE 54017 AAAA TCZZA