Alcatel-Lucent 7330 Product Information Manual page 230

3
4
5
6
7
8
9
10
11
Alcatel-Lucent 7330/7302 ISAM FTTN R04.02.41
3FE 54017 AAAA TCZZA
Figure NTP 122-1: Indoor ONT connections
Video coaxial
connector
Replace the indoor ONT with a new unit.
Connect the power, RF video, phone, and Ethernet connections to the ONT
(DLP 101, DLP 105, DLP 111, and DLP 115).
Connect the power cable to the ac outlet.
If used, configure the SLID (DLP 121).
Note — A new SLID or the old SLID may be used with the replacement
ONT. If a new SLID is used, the new SLID must also be programmed at
the P-OLT using TL1 or a network manager. If the old SLID is used, no
changes need to be made at the P-OLT; see the appropriate P-OLT
Operations and Maintenance Procedures Guide for more details.
If required, have approved service personnel who are trained to work with optic
fiber clean the fiber optic connection. See DLP
fiber optic handling, inspection, and cleaning.
Danger — Fiber optic cables transmit invisible laser light. To avoid eye
damage or blindness, never look directly into fibers, connectors, or
adapters.
Make the fiber optic connection using the fiber optic port shown in
Figure NTP 122-1.
Warning — Be careful to maintain a bend radius of no less than 1.5
inches (3.8 cm) when connecting the fiber optic cable. Too small of a
bend radius in the cable can result in damage to the optic fiber.
Verify the ONT LEDs, voltage status, and optical signal levels (DLP 119).
Activate and test the services (DLP 120).
STOP. This procedure is complete.
December 2010
Edition 01 ONT Product Information Guide
NTP 122 — Replace an I-241G-A indoor ONT
2 1 1 2 3
RJ-11 phone Ethernet
connectors ports
126 for more information about
PON
4
Power
Fiber optic
port connection
19397
NTP 122-3