Alcatel-Lucent 7330 Product Information Manual page 143

Task Procedure using
HTTP interface
Activating an To view current
ONT using an SLID settings
SLID
To clear the SLID
To enter the
SLID
(2 of 2)
5.4 Accessing or disconnecting from the HTTP or a CLI interface
This section shows you how to:
•
access the HTTP or a CLI interface
•
disconnect from the HTTP or a CLI interface
Prerequisites
The prerequisites are:
•
The ONT is installed.
•
The ONT is in service.
•
For an indoor ONT, the first Ethernet port, which is typically labeled 1 on the
ONT, is in service.
•
For an outdoor ONT, the ONT has a serial RS-232 craft interface.
•
For an indoor Package C ONT, the ONT has an Ethernet port in service.
Procedures using HTTP interface
The HTTP interface is accessible through the first Ethernet port on an indoor ONT
using a computer or laptop with an HTTP client. The ONT must support an HTTP
server, and the computer must have a supported HTTP client (Web browser).
The following procedures provide the steps to access and to disconnect from the
HTTP interface using the first Ethernet port.
Alcatel-Lucent 7330/7302 ISAM FTTN R04.02.41
3FE 54017 AAAA TCZZA
Procedure using
CLI interface
To view current
SLID settings
To clear the SLID
To enter the
SLID
Note —
Contact your Alcatel-Lucent technical support
representative for a list of supported Web browsers.
December 2010
Edition 01 ONT Product Information Guide
5 — ONT management using an ONT interface
Procedure using Procedure using
Package C ONT Package C ONT
HTTP interface CLI interface
To view current To retrieve the
SLID settings current SLID
settings
— —
To enter the To modify the
SLID SLID
Procedure using
butt set
—
To clear the SLID
using a butt set
To enter the
SLID using a butt
set
5-11