Alcatel-Lucent 7330 Product Information Manual page 255

NTP 125 — Replace an I-240G-B or I-241G-B indoor ONT
6
7
8
9
10
11
12
13
14
15
16
17
NTP 125-4
Connect the Ethernet cables (DLP 101).
Connect the POTS cables (DLP 115).
If required, have approved service personnel who are trained to work with optic
fiber clean the fiber optic connection. See DLP
fiber optic handling, inspection, and cleaning.
Danger — Fiber optic cables transmit invisible laser light. To avoid eye
damage or blindness, never look directly into fibers, connectors, or
adapters.
Connect the SC/APC fiber optic cable (DLP 117).
Warning — Be careful to maintain a bend radius of no less than 1.5
inches (3.8 cm) when connecting the fiber optic cable. Too small of a
bend radius in the cable can result in damage to the optic fiber.
Install the power supply according to manufacturer specifications.
Note — Observe the following:
Units must be powered by a Listed or CE approved and marked
•
limited power source power supply with a minimum output rate of
12 V dc, 1.25 A.
Connect the power cable with an 8-pin Molex connector to the ONT unit.
Power up the ONT unit by using the ON/OFF power switch.
If necessary, reset the ONT (DLP 118).
If used, configure the SLID (DLP 121).
Note — A new SLID or the old SLID may be used with the replacement
ONT. If a new SLID is used, the new SLID must also be programmed at
the P-OLT using TL1 or a network manager. If the old SLID is used, no
changes need to be made at the P-OLT; see the operations and
maintenance documentation for the OLT for more details.
Verify the ONT LEDs, voltage status, and optical signal levels (DLP 119).
Activate and test the services (DLP 120).
STOP. This procedure is complete.
December 2010
ONT Product Information Guide Edition 01
126 for more information about
Alcatel-Lucent 7330/7302 ISAM FTTN R04.02.41
3FE 54017 AAAA TCZZA