Alcatel-Lucent 7330 Product Information Manual page 155

ONT state
MOCA_LOSS_OF_LINK
MOCA_NOT_REG
MSG_ERROR_MSG
OMCC_NOT_ASSIGNED
OMCI_ENV1
OMCI_ENV2
ON_BATTERY
ONT_DEACTIVATE
ONT_DISABLE
ONT_RANGED
PHY_EQPT_ERROR_IN
PHYSICALEQUIPMENTERROR
PHYSICAL_LAYER_DISABLED
PHYSICAL_LAYER_INACTIVE
PON_HIGH
PON_LOSS
PON-LOW
(2 of 3)
Alcatel-Lucent 7330/7302 ISAM FTTN R04.02.41
3FE 54017 AAAA TCZZA
Description
There is a loss of link on the MoCA physical
interface between the ONT and the
broadband home router.
There is a loss of link on the MoCA physical
interface between the ONT and the
broadband home router
There is a physical layer error message from
the ONT.
The ONT fails to respond to OMCI message
requests, or loss of communication
State corresponds to a customer installed
device. The source of the ENV1 alarm, which
is the customer device, is at fault and must
be addressed by the customer.
State corresponds to a customer installed
device. The source of the alarm, which is
the customer device, is at fault and must be
addressed by the customer.
There is loss of external power to ONT, or
the ONT is on battery backup, or the power
supply failed.
There is a deactivate failure of the ONT.
The ONT has been autonomously disabled
because of misbehaving transmissions.
The ONTDISABLED alarm is a defense alarm
so that the ONT does not affect the entire
PON.
The ONT is ranged.
There is physical equipment error on ONT.
There is physical equipment error on ONT.
Contact your Alcatel-Lucent technical
support representative for information.
Contact your Alcatel-Lucent technical
support representative for information.
The 1490 nm optical signal level is too high.
The ONT polls this signal level once a
second, and indicates if the alarm condition
is present.
The P-OLT is not receiving transmissions
from the PON.
The state normally results from a fiber
pulled from the PON interface, or the feed
into a splitter.
State indicating if the 1490 nm optical signal
level is too low
The ONT polls this signal level once a
second, and indicates whether the alarm
condition is present.
December 2010
Edition 01 ONT Product Information Guide
5 — ONT management using an ONT interface
Alarm
MOCALOL
MOCALOL
MEM
OMCICOMM
ENV1
ENV2
ACFAIL (was PWR)
DF
ONTDISABLED
—
PEE
PEE
—
—
LEVELHI
PONLOS
LEVELLO
5-23