Alcatel-Lucent 7330 Product Information Manual page 229

NTP 122 — Replace an I-241G-A indoor ONT
Safety information
Read the following safety information before installing the unit.
Procedure
Use this procedure to replace an I-241G-A indoor ONT.
1
2
NTP 122-2
Danger 1 — Always contact the local utility company before you
connect the enclosure to the utilities.
Danger 2 — Observe the local and national laws and regulations that
may be applicable to this installation.
Warning — This equipment is ESD sensitive. Proper ESD protections
should be used when removing the fiber access cover of the indoor ONT.
Caution — Keep indoor ONTs out of direct sunlight. Prolonged
exposure to direct sunlight can damage the unit.
Note — Observe the following:
The indoor ONT should be installed in accordance with the
•
applicable requirements of the NEC or CEC. Local authorities and
practices take precedent when there is conflict between the local
standard and the NEC or CEC.
The indoor ONT must be installed by qualified service personnel.
•
Indoor ONTs must be installed with cables that are suitably rated
•
and listed for indoor use.
Deactivate the ONT services (DLP 123). If you are using the SLID feature, this step
is not required. The ONT and the services can remain in service (IS).
At the subscriber site, locate the indoor ONT and disconnect the power, RF video,
phone, Ethernet and fiber optic cables; see Figure
December 2010
ONT Product Information Guide Edition 01
NTP 122-1.
Alcatel-Lucent 7330/7302 ISAM FTTN R04.02.41
3FE 54017 AAAA TCZZA