Alcatel-Lucent 7330 Product Information Manual page 199
Intelligent services access manager fiber to the node
Hide thumbs
Also See for 7330:
- Information manual (1074 pages) ,
- Product information manual (420 pages) ,
- Operation and maintenance (20 pages)
Advertisement
9
10
11
12
Alcatel-Lucent 7330/7302 ISAM FTTN R04.02.41
3FE 54017 AAAA TCZZA
If a currently provisioned SLID contains nonnumeric digits, the ONT exits the SLID
output mode. If a currently provisioned SLID contains only numeric digits, the
value is displayed back to the installer using the POTS LED on the ONT. Each SLID
number is determined by counting the number of times that the POTS LED on the
ONT flashes, as follows:
If the SLID is in decimal format:
•
•
For the numbers 1 to 9, the flash pattern is 0.5 s of green light followed by
1 s of no light, repeated the number of times necessary to correspond to the
number.
For the number 0, the flash pattern is 0.5 s of green light followed by 1 s of
•
no light repeated 10 times.
•
There is a 3s interval between digits.
If the SLID is in hexadecimal format:
•
For the numbers 1 to 9, the flash pattern is 0.5 s of green light followed by
•
0.5 s of no light, repeated the number of times necessary to correspond to the
number.
For the number 0, the flash pattern is 0.5 s of green light followed by 0.5 s of
•
no light repeated 10 times.
•
There is a 3s interval between digits.
Note 1 — The SLID number displays more slowly in decimal format than
in hexadecimal format.
Note 2 — The SLID number can be verified at any time by connecting a
butt set to the first POTS port and dialing the "#" key.
Take the butt set on-hook to exit the SLID output mode.
Connect the PON optical cable to the ONT.
The ONT exits all SLID management modes.
Perform one of the following to provision ONT and services:
a
If the ONT and services were preprovisioned at the P-OLT, the P-OLT will
automatically range and provision the ONT, after the ONT is connected to the
PON optical cable.
b
If the ONT and services were not preprovisioned at the P-OLT, notify the TL1
or network manager GUI operator to provision the ONT and services at the
P-OLT using SLID.
STOP. This procedure is complete.
December 2010
Edition 01 ONT Product Information Guide
5 — ONT management using an ONT interface
5-67
Advertisement
