Alcatel-Lucent 7330 Product Information Manual page 192

5 — ONT management using an ONT interface
9
10
Procedures using CLI interface
The following procedures provide the steps to view the current SLID settings, to
clear the SLID, and to enter the SLID using the CLI interface.
Procedure 5-41 To view current SLID settings
1
2
5-60
Perform one of the following to provision ONT and services:
a If the ONT and services were preprovisioned at the P-OLT, the P-OLT will
automatically range and provision the ONT, after the ONT is connected to the
PON optical cable.
b If the ONT and services were not pre-provisioned at the P-OLT, notify the TL1
or network manager GUI operator to provision the ONT and services at the
P-OLT using SLID.
STOP. This procedure is complete.
Note —
To enter or clear a slid:
•
If you are using an Ethernet connection, the ONT must be
disconnected from the PON optical cable.
•
If you are using a craft connection, the ONT can be connected or
disconnected from the PON optical cable. However, if you
configure the SLID with the ONT connected to the PON optical
cable, the data at the ONT is not changed; the data at the ONT is
only changed after the ONT reranges. Rerange the ONT by
disconnecting and reconnecting the PON optical cable, which
generates a NEWONT alarm.
Choose option 4, Retrieve SLID, from the
The system displays the string format, the mode, and the value of the SLID.
Example:
The SLID in ALPHANUMERIC MODE (Volatile) : DEFAULT
where the SLID settings are described in Table
STOP. This procedure is complete.
December 2010
ONT Product Information Guide Edition 01
Main menu.
5-10
Alcatel-Lucent 7330/7302 ISAM FTTN R04.02.41
3FE 54017 AAAA TCZZA