Alcatel-Lucent 7330 Product Information Manual page 146

5 — ONT management using an ONT interface
3
4
5
Procedure 5-5 To disconnect from the CLI interface
1
2
3
5-14
Perform one of the following:
a If the ONT is not ranged, start a Telnet session and Telnet to 192.168.4.254.
telnet 192.168.4.254↵
Note — The 192.168.4.254 IP address remains open until the ONT has
been ranged. After the ONT has been ranged, the ONT no longer
accesses this IP address.
b If the ONT is ranged, start a Telnet session using the IP address of the ONT.
For example:
telnet 192.168.3.10↵
Log in to a Telnet session:
login:login
password:password
where
login is the username for the ONT
password is the password for the ONT
Note — The CLI interface requires a specific username and password.
Contact your Alcatel-Lucent technical support representative for login
and password information.
The Main menu appears.
STOP. This procedure is complete.
Choose option 9, Logout, from the main menu.
Perform one of the following:
a If you are connected to the CLI interface through a craft port, disconnect the
serial cable from the RS-232 connector.
b If you are connected to the CLI interface through the first Ethernet port,
disconnect the Ethernet cable from the first Ethernet port.
STOP. This procedure is complete.
December 2010
ONT Product Information Guide Edition 01
Alcatel-Lucent 7330/7302 ISAM FTTN R04.02.41
3FE 54017 AAAA TCZZA