Alcatel-Lucent 7330 Product Information Manual page 145

Procedures using CLI interface
The CLI interface is accessible in two ways:
•
craft port—The CLI interface is accessible through a craft port, which is provided
by some outdoor ONT models. You connect to the craft port with an RS-232
DB-9 connector, using a VT100 terminal or PC terminal emulation software set
at 9600 Baud, 8 bits, no parity.
•
Ethernet over LAN—The CLI interface is accessible through the first Ethernet
port on an indoor ONT using a computer or laptop with Telnet software.
The following procedures provide the steps to access and to disconnect from the CLI
interface using a craft port, or the first Ethernet port.
Procedure 5-3 To access the CLI interface using a craft port
1
2
3
4
Procedure 5-4 To access the CLI interface using the first Ethernet
port
1
2
Alcatel-Lucent 7330/7302 ISAM FTTN R04.02.41
3FE 54017 AAAA TCZZA
Connect a laptop via serial cable to the RS-232 connector on the ONT.
Configure the communications software to the following settings:
bits/second = 9600
•
data bits = 8
•
parity = None (N)
•
stop bits = 1
•
terminal emulation = VT100
•
Log in to a craft session:
login:login
password:password
where
login is the username for the ONT
password is the password for the ONT
Note — The CLI interface requires a specific username and password.
Contact your Alcatel-Lucent technical representative for login and
password information.
The Main menu appears.
STOP. This procedure is complete.
Connect a computer or laptop to the first Ethernet port on the ONT using an
Ethernet cable.
Configure the IP address on the laptop Ethernet port to 192.168.4.1.
December 2010
Edition 01 ONT Product Information Guide
5 — ONT management using an ONT interface
5-13